Roofing in Miami-Dade and Broward

Does Florida code require hurricane straps when you reroof in Miami-Dade or Broward?

Updated November 19, 2026 Reviewed by Brandon Vega, owner, Apex Roofing Solutions Corp. (license CCC1336242)
Attic view of roof trusses, metal connector plates and roof deck from below
Photo: Apex Roofing Solutions

Florida code can require roof-to-wall connection improvements when you replace a roof, but it does not require new hurricane straps on every house in Miami-Dade or Broward. Section 706.8 of the 2023 Florida Building Code, Existing Building ties that requirement to the roof deck, the building's location and value, and specified exceptions, with a 15% limit on mandated retrofit spending. The answer for your house also depends on its original permit records and existing connections. Apex Roofing Solutions Corp. offers a free roof inspection, a written price with every fee, and residential payments tied to permit approval and city inspections.

Key takeaways

  • Florida Building Code, Existing Building Section 706.8 sets a $300,000 value threshold along with roof deck and location conditions.
  • Section 706.8 limits mandated connection retrofits beyond a 15% increase in reroofing cost; that percentage is not an automatic charge.
  • Section 706.8.1 recognizes existing adequate connections and documented original construction requirements.
  • Sections 706.7.1 and 706.8 address different attachments: deck to framing, and roof framing to walls.
  • Apex starts residential replacement with a $500 deposit, then collects 35%, 35% and 30% of the balance at the specified permit and inspection stages.

Which conditions trigger the reroof connection requirement?

Section 706.8 applies when an existing roof covering is removed and replaced over a sawn lumber, wood plank or wood structural panel deck, the building is in the code-defined wind-borne debris region, and the specified building value is $300,000 or more. Its exceptions must also be checked.

The deck is the wood surface underneath your roof covering. Roof-to-wall connections are the attachments between the roof framing and the walls below. These are separate parts of the roof, so a proposal that discusses new deck nails has not necessarily answered your hurricane strap question.

For the value test, the section first uses insured value. If the building is uninsured, or documentation of insured value is not presented, it uses the structure's just valuation for property taxation. That wording matters. A home's advertised sale price is not the valuation described in this provision.

Ask your roofer to identify the applicable valuation document and explain how the location requirement was checked for your address. Then ask which exception, if any, applies. A clear answer should connect the code language to your actual house rather than stop at 'Florida requires straps.'

This explanation follows the 2023 Florida Building Code, Existing Building, Section 706.8. Have the building department confirm the requirements applicable to your permit before treating this page as the final scope for a Miami-Dade or Broward project.

Could my original construction records change the answer?

Yes. Section 706.8 exempts structures permitted subject to the Florida Building Code from this particular provision. Section 706.8.1 also recognizes documented original construction requirements for roof-to-wall connections or a continuous connection path from the roof to the foundation. A construction year alone does not establish either exception.

For the second exception, the code specifically identifies code adoption date documentation and permit issuance date. In plain terms, the question is what connection requirements applied when the home was originally permitted, supported by the records that establish those dates.

Start with the original building permit information if you have it. Bring any available structural drawings to the discussion as well. Ask the person preparing the reroof scope to identify the records supporting an exemption instead of relying on a broad statement about homes built before or after a particular year.

An exception to Section 706.8 does not mean your existing connections have been inspected and found adequate. It means that this specific retrofit requirement has an exception. Keep those conclusions separate when reviewing a proposal.

If records are missing, ask what further evaluation is needed before a connection allowance becomes part of your contract. The useful result is a documented reason for including or excluding the work, with the permit requirements resolved before installation.

How does the 15% limit affect the work on my house?

The 15% provision limits mandated connection retrofit work; it is not an automatic surcharge. Section 706.8 says mandated retrofits are not required beyond a 15% increase in reroofing cost. Section 706.8.1 also conditions the requirement on completing evaluation and installation at gable ends or all corners within that percentage.

Both parts matter. A contractor should explain the proposed connection work and show how the applicable cost condition was evaluated. A line that simply adds '15% for hurricane straps' does not tell you what will be inspected or what will be installed.

The code also sets priorities for mandated spending in Section 706.8.1.7. It gives priority to exterior roof corners where the roof framing spans are greatest. A span is the distance a framing member carries between its supports.

For a house with both hip and gable ends, the provision generally prioritizes the gable ends, unless the hip end is more than 1.5 times as wide as the gable end. It also addresses when the remaining budget does not complete the non-prioritized work.

Ask for the proposed locations in writing and an explanation of how those priorities apply. If you want work beyond the mandated scope, have that additional work identified separately so you understand the decision and the price before signing.

Do existing straps count, or must every connector be replaced?

Existing connections can count. Section 706.8.1 allows the required uplift resistance to be met by existing conditions or retrofit measures. Uplift is the upward force the connection must resist. Its prescribed methods also allow added fasteners in certain existing straps when the strap was manufactured to accept the required fasteners.

That means the presence of metal hardware is only the start of the evaluation. The applicable method also addresses its attachment. Under the listed hip and gable methods, the code uses a four-fastener condition at each end of the relevant straps and specifies connection requirements where that condition is not met.

Do not treat those numbers as instructions to add nails yourself. The appropriate method depends on the roof shape and whether the supporting wall is wood frame or masonry. The code's alternatives include an engineered design, and the required resistance must be established for the project.

Section 706.8.1.2 also addresses a partly inaccessible strap. If the observed portion is fastened in compliance with the requirements, the inaccessible portion is presumed to comply under that provision. That is a specific rule about a partly observed strap, not permission to assume that every hidden connection is acceptable.

Ask what was visible, what was verified from records, and what still needs access. Request photos that correspond to the written findings so you can understand why a connection is being kept, improved or replaced.

Where would the roofer need access to inspect the connections?

Section 706.8.1.1 allows access from beneath the eave, through the roof above, or from inside the house. The eave is the roof edge that projects beyond the wall. The access route should be discussed with the connection scope because it determines which surfaces must be opened and restored.

If roof panels or portions of panels are removed for access, the section says those removed portions cannot be reused. New paneling must be installed and fastened as required for new construction. The same section gives support and fastening conditions for permitted patches.

For gable roof methods, Sections 706.8.1.3 and 706.8.1.4 call for inspecting the anchorage of exposed rafters or trusses within 6 feet of the corner along the exterior wall on each side of each gable end. Rafters and trusses are the framing that supports the roof.

The hip roof methods in Sections 706.8.1.5 and 706.8.1.6 identify minimum access locations unless suitable anchorage can be verified through nondestructive inspection or design professional plans. Those locations include specified hip framing and each roof corner.

Before work starts, ask who will open the access areas and who will restore them. Ask how that restoration appears in the written scope. Book a free roof inspection with Apex Roofing Solutions Corp. to begin reviewing your roof and the questions that need answers before replacement.

Is refastening the roof deck the same as adding hurricane straps?

No. Section 706.7.1 addresses fastening the wood roof deck to the framing underneath it. Section 706.8 addresses connections between roof framing and the walls. Improving one attachment does not, by itself, establish that the other attachment has been evaluated or improved.

This distinction matters when comparing bids. 'Back nailing' means adding fasteners to the deck so it is securely attached to the framing. Hurricane strap work concerns the next connection, where that framing meets the wall below.

Section 706.7 also addresses a secondary water barrier, which is a layer intended to provide additional water protection beneath the roof covering. That is another separate item. A proposal can describe deck fastening and water protection while leaving the roof-to-wall question unanswered.

Ask for a separate explanation of each applicable part of the job. Which deck attachment work is included? What water barrier is specified? What roof-to-wall evaluation and improvements are included, or what documented exception applies?

At Apex, our residential replacement includes a full tear-off to the wood deck and a named underlayment product. We show you your own roof photos and separate what needs fixing from what is cosmetic. Use that same standard when reviewing the connection findings: the explanation should show what was found and why the proposed work follows.

Could a state mitigation grant help fund roof-to-wall improvements?

My Safe Florida Home can include roof-to-wall reinforcement among eligible improvements, but a grant is not guaranteed. Florida Statutes section 215.5586 requires the improvement to be recommended by the program's initial inspection. Funding depends on appropriations, and qualifying for an inspection does not automatically qualify you for a grant.

The 2026 statute sets additional grant conditions. These include an insured dwelling value of $700,000 or less and construction before January 1, 2008, as reflected on the county property appraiser's website. It also requires an initial program inspection within the preceding 24 months and low-income or moderate-income eligibility.

Those are different tests from the $300,000 reroof code threshold. One determines eligibility for a particular funding program. The other helps determine whether a code retrofit provision applies. Do not use approval or denial under one as the answer to the other.

The statute generally provides $2 from the state for each $1 from the applicant, up to a $10,000 state contribution. Qualifying low-income applicants may receive up to $10,000 without a matching contribution. Other eligibility conditions still apply.

Program work requires applicable local permits and inspections and properly licensed contractors. The final program inspection must identify the improvements for grant payment. Confirm program approval and its requirements before relying on grant money in your roofing budget.

How will Apex write the connection scope and payment terms into my proposal?

Apex prices residential roof replacement after inspection and puts every price, fee and term in writing before work starts. Your proposal should make clear what connection work is included and what remains to be evaluated. Our residential payment schedule starts with $500 at signing, followed by payments tied to permit approval and inspections.

After the deposit, you pay 35% of the balance when the city approves the permit. Another 35% is due after the in-progress inspection passes. The remaining 30% is due after the final inspection passes. Financing is available, with the monthly payment shown on your quote.

Now, the money concern is understandable: you want to know whether the bill will grow after the old roof comes off. Rotten deck wood is priced per sheet in our contract. Fascia and soffit are priced per sheet or per foot as applicable, and you are charged only for what is actually replaced. Permit fees are also listed in the contract.

For comparison, Apex's installed planning ranges as of November 11, 2026 are $6 to $7.50 per square foot for architectural shingles, $9.75 to $11 for concrete tile, and $11 to $13 for 24 gauge standing seam metal. These are not quotes or separate strap installation rates. The existing roof, selected underlayment, chosen system and roof complexity affect the price.

Our residential replacements include a written 10-year workmanship warranty, plus the manufacturer warranty where the system has one. Manufacturer coverage depends on installation to its specifications. Apex Roofing Solutions Corp. is licensed and insured, Florida license CCC1336242, and serves Miami-Dade and Broward from Miami Lakes.

Call 305-290-2482 to book a free roof inspection with no obligation. Bring any original permit records you have and ask us to walk through the proposed roof scope with you. You should understand the connection question and the written payment terms before choosing your roof.

Questions homeowners ask

Does replacing my roof automatically mean installing all new hurricane straps?

No. Section 706.8 establishes conditions and exceptions for the reroof connection requirement. Section 706.8.1 also allows existing connections to satisfy the required resistance. Depending on the applicable method and existing hardware, qualifying work can include adding fasteners rather than installing a new strap.

Is the $300,000 threshold based on what I could sell my house for?

Section 706.8 uses insured value first. If the building is uninsured or documentation of insured value is not presented, it uses the structure's just valuation for property taxation. The threshold is $300,000 or more. Do not substitute an asking price or a combined land and building figure without checking the required valuation.

Does the 15% provision mean my roofing bill automatically increases by 15%?

No. Section 706.8 limits mandated connection retrofits beyond a 15% increase in reroofing cost. Section 706.8.1 also includes a condition about completing evaluation and installation at gable ends or all corners within 15% of replacement cost. Ask for the actual scope and its calculation.

Can my house be exempt even if it is older?

Possibly. Section 706.8.1 recognizes documentation showing that roof-to-wall connections or a continuous connection path from roof to foundation were required when the house was originally built. The provision calls for code adoption and permit issuance dates. Age alone does not establish that exception.

Can My Safe Florida Home help with connection improvements?

Florida Statutes section 215.5586 lists reinforcing roof-to-wall connections among eligible improvements when recommended by the program's initial inspection. Eligibility, approval and available funding still apply. Inspection eligibility does not by itself establish grant eligibility, and the program does not create an entitlement to funding.

What does Apex charge, and when would I pay?

Apex prices your roof after inspection and lists every fee in writing. For a residential replacement, you pay $500 at signing, then 35% of the balance at city permit approval, 35% after the in-progress inspection passes and 30% after the final inspection passes. Rotten deck wood is priced per sheet in the contract. Fascia and soffit are priced per sheet or per foot as applicable, and financing is available with the monthly payment shown on your quote.

Sources

Free Estimate

Tell Us About Your Roof

Share a few details and our team will follow up with the next step.

  • Roof repairs, replacements, and inspections
  • Tile, shingle, metal, and commercial roofing
  • Serving Miami-Dade, Broward, Palm Beach and Monroe counties

Prefer to talk to a person?

Call now if you need help today.

305-290-2482